• Axle WeighingMonitor yields, loads, waste and compliance
  • Document truck weights and eliminate overload fines.
  • Determine and maximise your load and axle weights before you go over a weighbridge.
  • Relocatable design for rented or variable work sites.

About

Drive over the scale at a constant ~3MPH (~5km/h). The scale will automatically weigh each axle and print a receipt with individual axle weights and the total. If you store the trucks ID and tare weight, or use 2 pass weighing, the controller will calculate the Gross, Tare and Net values.

Axle Weighing

موازين محاور للطرق:

Easy

Just install, add power, zero the scale and start weighing. موازين محاور للطرق is preconfigured for easy installation. The load cells are factory calibrated and the indicator is preprogrammed. All wiring is DIY terminating with screw on watertight M12 connectors.

Accurate

On average better than ± 0.5% repeatability can be expected. Company testing as well as numerous field installs have shown that with extended flat and level concrete approaches better accuracy can be achieved. Individual results may vary. Well maintained vehicles weigh the best. Never worry about being overloaded again.

Economical

About 1/3 of the cost of a full length truck scale. With the Weigh In Motion موازين محاور للطرق you will always know the total vehicle weight and the individual axle weights. Installation generally takes half a day and no costly foundation work. No limit on the number of axles, allows for any truck configuration or length. Can even be installed in a gravel driveway removing the need for costly approaches and exits.

Innovative & Trusted

This patented design produces fast accurate weights without stopping on the scale or interrupting the flow of traffic. Farm and jobsite management software creates a CSV file for every transaction with “farm and field” or “material and Job”

User Installation

Components

Single Pass Weighing With Known Tare Weigh

Axle Weighing

 

  • Configure the truck empty weight
  • ID the truck and proceed across the scale
Two Pass Weighing – Weigh In and Weigh Out
Axle WeighingINBOUND
  • ID Truck then drive across the scale
OUTBOUND
  • ID the Truck again and drive across the scale.