موازين محاور للطرق | منتجات الوزن و القياس

موازين محاور للطرقMonitor yields, loads, waste and compliance

تسجيل أوزان سيارة النقل و الغاء ما قد يتسبب فى غرامات.
اعرف الوزن المضبوط و تأكد من أنه لم يتعدد الوزن المسموح به قبل الصعود على محاور الطرق
Relocatable design for rented or variable work sites.

About

Drive over the scale at a constant ~3MPH (~5km/h). The scale will automatically weigh each axle and print a receipt with individual axle weights and the total. If you store the trucks ID and tare weight, or use 2 pass weighing, the controller will calculate the Gross, Tare and Net values.

موازين محاور للطرق:

سهل

Just install, add power, zero the scale and start weighing. موازين محاور للطرق is preconfigured for easy installation. The load cells are factory calibrated and the indicator is preprogrammed. All wiring is DIY terminating with screw on watertight M12 connectors.

دقيق

On average better than ± 0.5% repeatability can be expected. Company testing as well as numerous field installs have shown that with extended flat and level concrete approaches better accuracy can be achieved. Individual results may vary. Well maintained vehicles weigh the best. Never worry about being overloaded again.

اقتصادى

About 1/3 of the cost of a full length truck scale. With the Weigh In Motion موازين محاور للطرق you will always know the total vehicle weight and the individual axle weights. Installation generally takes half a day and no costly foundation work. No limit on the number of axles, allows for any truck configuration or length. Can even be installed in a gravel driveway removing the need for costly approaches and exits.

موثوق فيه

This patented design produces fast accurate weights without stopping on the scale or interrupting the flow of traffic. Farm and jobsite management software creates a CSV file for every transaction with “farm and field” or “material and Job”

User Installation

Step1: Choose site that is flat and level twice the length of your longest truck

Step2: Excavate and compact 14' (4.26m) X 10.5'(3.2m) x 2' (0.6m) deep. Dig a trench for home run cable and water drains.

Step3: Lay 4'' (101.6mm) drain coil and first 6''(150mm) layer of 0.78''(20mm) road crush stone. Compact to 95%

Step4: Lay second layer of 0.78''(20mm) road crush stone, compact to 95%. Surface should be 11.61'(295mm) below grade or approach.

Step5: Entire foundation must be flat and level. This critical step is best achieved with a laser level to ensure accuracy.

Step6: Set 50'(15.24m) of builder's string line parallel to the approaches and install the scale along this line.

Step7: Slope 4"'(101.6mm) PCV storm water pipe away from foundation and run 1''(24mm) conduit from scale to controller. Back fill perimeter of scale, drains and conduit runs.

Step8: Install home run cable from controller to 4 way connection. Terminate the watertight loadcell connections at scale and controller using the M12 screw on connectors.

Step8: Install home run cable from controller to 4 way connection. Terminate the watertight loadcell connections at scale and controller using the M12 screw on connectors.